Archive of the former Yahoo!Groups mailing list: Discussion about the Korg PolySix synthesizer

previous by date index next by date
  topic list next in topic

Subject: (new) KLM 367 Calibration issue

From: "Daniel A" <apophis93@yahoo.com>
Date: 2010-08-20

Hello all just seeing if anyone can help me with an issue.

I have completed one of my new group buy KLM-367. Now it is installed and I am attempting to calibrate the board. I have completed both the power supply calibration and Step (1) resetting. Now with step (2) the D/A adjustment I am running into a problem. I set SW1 to test then toggle the Tape SW and LEDs 1 and 5 turn on. rotating VR7 or VR6 does not change the state of the LEDs.

Any clues?

Also has anyone run across a mod in their polysix where on the 369 the trace between D1 and J2 has been cut and then a jumper wire was installed to another location? I have a loose jumper wire coming from D1 for the time being I have soldered to J2 until I figure out why and where it was rerouted to.

- Daniel