Hi Andy
I'm working on the original KLM367 board.
Cheers
Aniello
--- In PolySix@yahoogroups.com, Andrew Jury <andy@...> wrote:
>
> Are you working on an original KLM-367 or trying to calibrate the clone
> board?
>
> Cheers,
> Andy
>
>
> On 05/07/2010 22:26, "aniello.iaccarino" <ani.bliss@...> wrote:
>
> >
> >
> >
> >
> >
> > Hi Friends
> > I recently did the adjustment procedure and I found two problems.
> >
> > The first is: not all the leds BANK A-D, PROGRAMS 1-8, MANUAL and TAPE
> > ENABLE lights up when i turn VR1 from left to right, but every time I
> > pass a certain point of VR1 leds light up in different combinations.
> > [[-(]
> >
> > I have to say that I can proceed to the calibration procedure anyway.
> > But I don't know If the result of the calibration procedure could be
> > better if all leds light up instead some of them.
> >
> > The second i found is that when I regulate MG speed I can't obtain a
> > cycle of 10-40 sec, but just 4 sec, a very short cycle. [[-(]
> > For this problem have I to check IC21 and C19?
> >
> > Any suggestion? [:D]
> >
> > Thanks
> >
> > Aniello
> >
> > [Non-text portions of this message have been removed]
> >
> >
> >
> >
> >
>
>
>
> [Non-text portions of this message have been removed]
>