Are you working on an original KLM-367 or trying to calibrate the clone
board?
Cheers,
Andy
On 05/07/2010 22:26, "aniello.iaccarino" <ani.bliss@gmail.com> wrote:
>
>
>
>
>
> Hi Friends
> I recently did the adjustment procedure and I found two problems.
>
> The first is: not all the leds BANK A-D, PROGRAMS 1-8, MANUAL and TAPE
> ENABLE lights up when i turn VR1 from left to right, but every time I
> pass a certain point of VR1 leds light up in different combinations.
> [[-(]
>
> I have to say that I can proceed to the calibration procedure anyway.
> But I don't know If the result of the calibration procedure could be
> better if all leds light up instead some of them.
>
> The second i found is that when I regulate MG speed I can't obtain a
> cycle of 10-40 sec, but just 4 sec, a very short cycle. [[-(]
> For this problem have I to check IC21 and C19?
>
> Any suggestion? [:D]
>
> Thanks
>
> Aniello
>
> [Non-text portions of this message have been removed]
>
>
>
>
>
[Non-text portions of this message have been removed]