Hi Andy,
Any similar thoughts on capacitors? There are so many types out there, the
cheapest being the little ceramic discs. Would it hurt to use a more
expensive cap of different material in its place if capacitance is the same
and voltage requirements were met, and it's non-polarized?
Don B.
_____
From:
PolySix@yahoogroups.com [mailto:
PolySix@yahoogroups.com] On Behalf Of
Andrew Jury
Sent: Friday, May 28, 2010 11:33 AM
To:
PolySix@yahoogroups.comSubject: Re: [PolySix] Re: [Group Buy PCBs]
Hi,
There is no problem with this. However, 5% carbon film resistors are general
less expensive because of their lower tolerance. Try and stick to the spec
if you can, but never use a lower tolerance component where a higher is
specified! I.e. 5% instead of a 1%, etc
Cheers,
Andy
On 28/05/2010 14:46, "
del_poolp@hotmail.com <mailto:del_poolp%40hotmail.com>
" <
del_poolp@hotmail.com <mailto:del_poolp%40hotmail.com> > wrote:
>
>
>
>
>
> Hi,
>
> I have another question.
>
> You think that have a problem there if I use only resistances metal 1 %
(on
> the place of 5%) ??? it's ok for recent project, but for this old system
????
>
> Thanks,
> PooLP
>
> PS : Sorry for my english
>
>
>
>
>
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]