I have one voice (5) that was out of tune for ages, couldn't tune it up as it was beyond what the pots allowed. Swapped chips and it was still voice 5 (so circuitry). However, it's recently started being 'in tune' very quickly and is now only slightly off (and probably could be tuned up properly again using the pots when I get chance). I'll have to look into cleaning it all if that may help.
To:
PolySix@yahoogroups.comFrom:
backshall1@bellsouth.netDate: Thu, 1 Apr 2010 08:43:47 -0400
Subject: RE: [PolySix] P6- all programs don't save EG and VCF levels (not properly)
Success! The new TC5514 is installed and I have 32 working presets. The
other main problem on this Polysix is related to at least a couple of other
threads I've seen people discussing. It used to have major problems with
distortion on voices 5 and 6. After hosing it down with deoxit a couple of
times and doing a lot of detailed cleaning, it is now to the point where the
distortion is just about gone, but these two voices still take a lot longer
than the others to warm up and get in tune. For voice 5, that could be 30
minutes. I don't know why there is so much crud on the 366 board in the area
of IC 35-38, or what it is or why it's so hard to get off, but I intend to
just keep cleaning since it makes a noticable difference every time I get an
area cleaned.
Don B.
_____
From:
PolySix@yahoogroups.com [mailto:
PolySix@yahoogroups.com] On Behalf Of
backshall1 (dsl)
Sent: Thursday, March 25, 2010 8:28 AM
To:
PolySix@yahoogroups.comSubject: RE: [PolySix] P6- all programs don't save EG and VCF levels (not
properly)
I ordered half a dozen TC5514 APL-3 chips from Quest. I hope this chip fixes
it. I couldn't think of any other explanation.
Don B.
_____
From: backshall1 (dsl) [mailto:backshall1@bellsout
<mailto:backshall1%40bellsouth.net> h.net]
Sent: Thursday, March 18, 2010 7:43 AM
To: 'PolySix@yahoogroup <mailto:%27PolySix%40yahoogroups.com> s.com'
Subject: RE: [PolySix] P6- all programs don't save EG and VCF levels (not
properly)
There is only one memory chip, the TC5514.
Don B.
_____
From: pietro [mailto:pietrobeatrice@ <mailto:pietrobeatrice%40hotmail.com>
hotmail.com]
Sent: Wednesday, March 17, 2010 5:43 PM
To: backshall1@bellsout <mailto:backshall1%40bellsouth.net> h.net
Subject: RE: [PolySix] P6- all programs don't save EG and VCF levels (not
properly)
Hallo Don B!!!
what we gona do? I guess if the memory for vcf and eg are different chip
from the other....
...maybe I have to study more the circuit...
waiting for good news from you...
regards
petrolio
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]
_________________________________________________________________
Send us your Hotmail stories and be featured in our newsletter
http://clk.atdmt.com/UKM/go/195013117/direct/01/[Non-text portions of this message have been removed]