Count me in for a new KLM367 too! I just powered up my P6, having not
played it for a few months, and the rather extensive repair I did to the
KLM367 is failing already. I must have missed something, because the
lithium battery is completely drained, the preset sounds are gone, and
the preset LEDs are acting erratically again. It works fine in manual
mode, but any attempt to load the factory sounds causes the P6 to
crash. It was working 100% a few months ago.
I think new boards are the only long term solution.
Cheers
Frank
Jed Jorgensen wrote:
>
>
> Hi all,
>
> We are still working on this. Troubleshooting has taken a lot longer than
> expected and we're still working out a few bugs. Andy has been fantastic
> help in figuring out what the problems are. Once we finish that (I
> hesitate
> to provide an estimate as to when since I've been so far off up until now)
> we will get a final count and do a run of the boards.
>
> Given the general level of interest, I'm guessing we're talking about a
> fairly small production run. Somewhere between 30-50 PCBs total, unless a
> bunch of people show up wanting one all of a sudden. At that scale,
> the cost
> is likely to be a bit higher than I was hoping. We're probably looking
> at a
> PCB somewhere in the $30 range, plus shipping.
>
> Best regards,
>
> Jed
>
> .
>
> __,_._,_