Check the connections to latch IC34, especially if you have had a battery
problem with your '367!
Cheers,
Andy
From:
PolySix@yahoogroups.com [mailto:
PolySix@yahoogroups.com] On Behalf Of
mborish_2000
Sent: 05 August 2009 06:48
To:
PolySix@yahoogroups.comSubject: [PolySix] Re: Problems with parasitic LFO in VCA?
That solved it. Thank you so much Klosmon. Unsuprisingly, I discovered
another problem after the first one. My Effects section is always engaged
and is producing some strange ring modulation type sounds depending on the
value of the speed/intensity knob. Is this related to the first problem?
-Mike
--- In
PolySix@yahoogroups.com <mailto:PolySix%40yahoogroups.com> , klosmon
<klosmon@...> wrote:
>
> One frequent problem with the CPU board can cause unwanted modulation of
> the VCO, which can sound like what you're describing.
> To see if this is the case, get a soldering iron & lift one end of R9,
> which is a 10K resistor located between IC8 and CN05.
> This will disconnect all modulation to the VCO; if it eliminates the
> problem, let me know, and I'll describe where to go f rom there.
>
> ~GMM
>
> mborish_2000 wrote:
> >
> >
> > I've got a few problems that I can't figure out. Unfortunately, my LFO
> > is bleeding into the VCA? and I can't figure out a way to stop it.
> > It's not a violent bleed but it's enought to make the Polysix
> > unusable. If I turn all of the controls down, it is still there. All
> > of the controls are functional. All of the potentiometers test out OK.
> > I tested all cables for continuity. I cleaned the LFO modulation
> > select switch and replaced the 4051 on KLM 369 without any luck. I
> > read somewhere that somebody suggested cutting a trace, but they
> > couldn't remember enough details about what they did. I didn't see any
> > calibration proceedure related to the LFO modulation either.
> > Everything else works fine.
> >
> > Does anybody have any suggestions? Logic and microprocessing are
> > really beyond my knowledge.
> >
> > -Mike
> >
>
>
> >
>
>
>
> [Non-text portions of this message have been removed]
>
[Non-text portions of this message have been removed]