Hi all again,
Just to let you know that it was in fact the opto on the oscillator
board. I have several of these boards with the same problem and this
has been the same problem on all. Basically it's impossible to tune
the unit and the "intonation" is out when you attemp to tune it.
--- In
PolySix@yahoogroups.com, "darke_one666" <darke_one666@y...>
wrote:
> I have an old P6 that I'm restoring. I've manged to get every part
> working but the damn thing will not tune. I substituted the voice
board
> and CPU board over and still the problem is the same. The power
supply
> rails are rock solid. It has been suggested that the boards I have
> fitted (obviously second hand) could be suffering from an
> inherent/common problem and I'm beginning to agree this is
possible.
> Basically if I tune C6 as described in the service manual all is
well,
> I then adjust VR1 to get C2 into tune but when I do this C6 is now
> pitched at D#6. On checking C0 or C1 it reads B flat (C2 remains
in
> tune and C3 is more or less in tune). I have set up several Poly
6's in
> the past and have never come across this problem. When I measure
the CV
> with C0-C5 held, the voltages are not exactly 0.5v apart but I
can't be
> sure if they are usually precisely 0.5, 1.0, 1.5v etc at the
octaves
> are triggered. I've read on the forum about the opto but because
the CV
> descrepancy I'm not too convinced at the moment. Any ideas,,please
help
>
> Thanks