Hi!
Have you contacted Roland directly? I've found that eventhough they might not actually have the part, they should be able to point you toward an 'Official Roland Repair Centre' who can sell you the part. I've had to do this a couple of time and have been reasonably successful.
Also, if it's just a pot/slider, can you not measure the resistance range of that/another slider and try to find one from a new manufacturer? eBay's also worth a shot as some guys are making replacement sliders for Junos etc and they might fall into the right range.
Good Luck!
Clive <analogue@...> wrote:
Hi All,
I need to replace a slider in an old piece of kit and I can't seem to
find a manufacturer let alone anything else.
I hope you don't mind me asking you good people.
The slider's part number is EVAL0PC15A26 and it has a rating of '2MA'
(I don't even know what that means, I'm used to Ohms!)
The slider is used to control 'Portamento' in both the Roland CSQ-100
Sequencer and their SH09 synth. It is for the former that I need it.
Any equivalent would be fine, it's not a control I will be using.
If it's any help, there are some service docs here:
http://www.synthesizerarchiv.de/circuits/roland/sh09/sh09.pdf
Any help will be greatly appreciated.
Thanks,
Clive.
Do you Yahoo!?
Check out the new Yahoo! Front Page. www.yahoo.com