Oh Fiddlesticks (there's one we haven't heard for a while!) :-). I grabbed
the wrong pack of resistors and wound up making a 2.42K 1% in my effort to
make 2K. Slapping about 11.6K across it brought everything in to where it
calibrates now. -Bob
----- Original Message -----
From: "Bob Weigel" <sounddoctorin@...>
To: "oldsynth group" <oldsynths@yahoogroups.com>
Sent: Sunday, November 02, 2003 11:45 PM
Subject: [oldsynths] Octave Cat SRM allignment/calibration proceedure?
> Well, I got the thing fixed. The bloomin' 2K resistor went open that's in
> the temp compensate position over the CA3046 transistor array...and made
an
> op amp go offset that overloaded the 330 ohm loaded power source! My
> diagram does NOT show that! Weak. Oh well..lot of wasted time there.
But
> now it's hard to calibrate. Using the keyboard current trim I can get the
> note spacings right on osc 1 and that seems the only way. But then other
> things are just way out of wack still. I'm not sure it will calibrate but
a
> good proceedure is the place to start of course if possible. -Bob
>
>
>
>
>
> To unsubscribe from this group, send an email to:
> oldsynths-unsubscribe@yahoogroups.com
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>
>