> But I am puzzled by the fact that your unit had four outputs.
Normally
> one would expect just two outputs, X and Y. Both outputs would
usually
> be allowed to go either +ve or -ve.
I can't remember... Looking now at the schematic, I originally
intended just 2 outputs. I had a few issues once I had it built. I
think when it just had 2 outputs, somehow it would combine to 0-18v.
Then, I tried to send the + to one lug, and the - to the other, but
then that caused problems grounding with the chassis. I think I may
have just run out of ideas by then, and seperating them worked. Now,
what's the simple solution? I know I'm going to kick myself...
-Mike Walters
www.mysterycircuits.com