how would one integrate a new power supply such as the one below with an
existing motm-900 in such a way as that the switch on the existing 900
turns on both the new Power One and the existing 900?
mark
At 04:56 PM 8/6/00 -0400, you wrote:
>In a message dated 8/5/2000 8:14:13 PM, synth1@... writes:
>
> >2) If you are planning a cabinet that holds over 22 MOTM modules, then
> >I
> >∗strongly∗ suggest getting a larger supply. I suggest the Power One model
> >HBB15-1.5-A. It is 1" larger in all 3 dimensions, but can power twice as
> >many
> >modules.
>
>This is the PSU I've been using. I was able to mount it to the 900 front
>panel by merely (very carefully) drilling two mounting holes through the
>PSU's brushed aluminum body. It's a bit of a tight fit, but it will work.