I have noticed that sometimes in low light conditions, my eyes get fooled
when looking at MOTM panels. It becomes hard to visually group knobs
together into a module at a glance, especially if you have a big wide wooden
cabinet instead of rack mounts.
I wondered why Paul chose not to screen a border around each module, and if
anybody else has had this problem besides me. If so, does anyone have a
solution?
I was idly thinking about a vertical edge begween modules created by a thin
strip of metal with a 'T' cross section, that could be slipped between them.
It would give it sort of that classy Moog module "aluminum border" look. It
would have to be awful thin, or the module spacing would be thrown off.
Comments?
Dave Bradley
Principal Software Engineer
Engineering Animation, Inc.
daveb@...