>
> Cast one vote for 24U length. I guess I could cut down from 26U.
Oh, come on! You can use 2 more VCOs!
>
> Explain to me why this does not allow one to bolt the big honking rack
> rails back to back for "butt-ended" rows one on top of another.
There is no end support. And, not everyone relishes the thought of drilling
11 gauge steel.
> That might be OK depending on the answer to my above question. If I were
> planning to "butt-end" two rows on top of one another, or bolt top and
> bottom rows to some kind of "magic bus," I would want my joints to be
> staggered, not in the middle. For the 26U example above. I would want
say
> one 16U and one 10U length so the but would not be at the same point on
> both crossing rails. However, if the answer to above says they cannot be
> "butt-ended" this is a non issue..
I don't want to have 2 different part numbers (short one/long one) to keep
track of.
Call me lazy.
Paul S.