I think you might have "the wiggle" because the nuts behind the faceplace were
not carefully cinched up equally behind the faceplate. If you have a very
thin-profile wrench that fits that nut you should be able to adjust them
without removing anything.. Or, you can remove the knobs and nuts from the
front, remove the bracket from the panel, and try to line up the nuts that way.
I have some slightly loose pots that I need to "fix" too. Not strangely,
Paul's "factory" modules dont exhibit this behavior :)
--- doctorvague <
phil-brown@...> wrote:
> 2) all the black PC-mounted pots are fine.
> All 3 panelmounted blue pots have considerable wiggle in the shaft and the
> freq (top) knob is
> the worst. Are these just worn out and need replacing, or is this the nature
> of these? I'll
> replace them either way as I'm not digging the shaft wiggle at all.
screw the RIAA. artists, take control.
share and remix music, legally, on your own terms.
http://ccmixter.org ____________________________________________________________________________________
Need a vacation? Get great deals
to amazing places on Yahoo! Travel.
http://travel.yahoo.com/