My approach was to place one of the 12 connector PCBs in each cabinet which
houses 2 rows of 12U. I removed the terminal PCB from the 900 and
replaced it with terminal strips. I then ran 14ga leads to each PCB from
the 900's.
dave
At 04:39 PM 4/9/01 +0000, you wrote:
>What do you folks do for power cables inside your MOTM systems? The
>power cables that come with the kits seem to be a bit on the short
>side. Is it correct to assume that many of you have just ordered
>connector parts and built longer cables?
>
>I have found that things pretty much don't reach if you are doing more
>than 2 rows of MOTM modules in a 19" rack.