Hey all,
I got the Moogslayer info about a year ago, and now I've finally got around
to doing something about it. I dug out the docs that I downloaded, and
apart from the stuff from the 'official' moogslayer site (
http://synthmod.net/korg/moog_slayer), I've got a hand-drawn picture from
someone who has added a switch so that the moogslayer can be switched out,
and it returns to the factory settings.
My problem is that I can't remember where I got that picture, and I can't
find it on the net, and I have a question about it.
So I'll ask the question here - maybe one of you has done this mod.
The 'extended' moogslayer has two resistors that replace the pots VR2 and
VR5, in the 'switched-out' position, so the moogslayer mods are out of the
circuit. The instructions say to use resistors the same value as the two
pots, "which may be different on each single Poly800". My electronics
knowledge doesn't go far beyond using a soldering iron, so I'm not sure how
to ascertain the value of the pots. Can I just measure the resistance
between two of the three pins? Which two pins? Do I need to desolder them
first?
Any help would be greatly appreciated. I can email the photos, but I'm
reluctant to put it in the photos section until I find out where it comes
from, and if the mod is reliable.
Cheers,
Reidar
∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗
NOTICE - This message is intended only for the use of the
addressee named above and may contain privileged and
confidential information. If you are not the intended recipient
of this message you are hereby notified that you must not
disseminate, copy or take any action based upon it. If you
received this message in error please notify HIC immediately.
Any views expressed in this message are those of the individual
sender, except where the sender specifically states them to be
the views of HIC.
∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗∗