Archive of the former Yahoo!Groups mailing list: Korg Poly800/EX800 Users

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [korgpolyex] Late! install of v1.3 hawkmod in ex800

From: <backshall1@...>
Date: 2019-08-29

Best bet for removing multi-pin parts is ChipQuik alloy (or similar). Remove as much solder as possible, melt some ChipQuik on each pin, run the soldering iron over all the pins one last time and the alloy will stay liquid for a few seconds so the chip can all be removed at once.
Don B.
 
Sent: Thursday, August 29, 2019 5:28 PM
Subject: Re: [korgpolyex] Late! install of v1.3 hawkmod in ex800
 
 

If I were to do it again, I would just clip the legs off that IC and then remove the cut off leads from the pcb one at a time...

You won't ever need that eeprom again.  And even if you did, there's plenty around extra or you can get one burned for you.