Archive of the former Yahoo!Groups mailing list: Korg Poly800/EX800 Users

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [korgpolyex] 2.65k Poly Key Assign Mode Values..

From: Michael Hawkins <korgpolyex800@...>
Date: 2017-04-03

No, extended parameter P2 88 is the same. What has changed is MIDI controller 86d (56H) which was for MIDI CC control of key assign mode.

The MIDI CC 86 has changed to use 0-4 values instead of a ranged 0-127. Look at the MIDI implementation chart for details.

So you're precious code is OK.

I've been doing the HAWK project for nine years. So don't give up on your project in under nine months. You have a long way to go yet. :-)

/Mike


From: "bperkins211@... [korgpolyex]" <korgpolyex@yahoogroups.com>
To: korgpolyex@yahoogroups.com
Sent: Sunday, April 2, 2017 6:59 PM
Subject: [korgpolyex] 2.65k Poly Key Assign Mode Values..

 
Saw the post about 2.65k fw.


        "I also modified CC control 86 (Poly Key Assign set) so that it uses absolute data values (0-4) corresponding with modes Poly, Hold, Chord, Portamento Mono and Portamento Unison."



Has the Poly Key Assign Mode been moved from Parameter Extended 88 to 86?
Also, it's been changed from the standard Rx midi values of 0-127 to 0-4??

If so, I need to change the GUI to match.  The version I was about to release will not work on the previous versions of FW anymore for the Poly Key Assign Mode parameter.

The GUI is completely set up to Rx the Patch Dump actual parameter values, converts those values to 0-127 for all knob/slider controls..  those controls are all set up to Tx to the HAWK 0-127 values.
I don't think I could find time to go in and change all the scripts and all the knob controls if it all changes to actual values.. it would take so much time I would probably get frustrated and give up on the project.