| previous by date | index | next by date |
| previous in topic | topic list | next in topic |
UPD.: It powers on. But it didnt recieve midi from keyboard. However I tried it with sequencer. And some strange things going on. DCO1 octave 1,2 make noises and waves do not switch. DCO2 octave 1 make noise and wave can`t be switch. Also can`t get work release for dco1 or dco2 env.
---In korgpolyex@yahoogroups.com, <b.mlaster@...> wrote:The good news it works without jumper, with original ROM and IC29 in sockets. I assume nothing damaged on mainboard and sockets soldered well. Should it power ups with original ROM and IC29 but with write jumper? Because first time I forget to desolder jumper, and it didn`t power up.
Does it mean that problem in hawk board? Is there are any steps how to check it? Because visually soldering seems ok.
---In korgpolyex@yahoogroups.com, <korgpolyex800@...> wrote:If you replace IC29 and remove the "write jumper" and place the original ROM into the ROM socket then it should work as original.
The board is only double sided. It has no internal layers. So top and bottom is all you have to worry about.
The other thing to watch is that I've had a couple of customers with the power rails trimmed too low and when the HAWK board was added in the voltage dropped just a little more and so HAWK would not work until the +5V rail was set back to exactly 5V. But that is a rare problem.
Mike
On Monday, October 21, 2013 4:10 PM, "b.mlaster@..." <b.mlaster@...> wrote:
I put original IC22 and IC29, that didnt help(
---In korgpolyex@yahoogroups.com, <b.mlaster@...> wrote:I checked all pins by manual, and all pins shorts like in manual. Also when I turn on ex800 psu make noise, so I suggest it not totally dead. Maybe something wrong with screen?How I can make further checks?Is the motherboard multilayered, and there are copper tracks inside? Desoldering was a pain, and maybe I damaged tracks that inside the board.If i put original IC22 and IC29 in sockets, it should work as original, right? (little problem, I broke one leg of EPROM)
---In korgpolyex@yahoogroups.com, <korgpolyex800@...> wrote:Yes, almost any multimeter will be OK for testing.
Mike
On Sunday, October 20, 2013 8:02 AM, "b.mlaster@..." <b.mlaster@...> wrote:
Hello,I installed kit, and it doesnt` power on. So now I am troubleshooting it with "troubleshoot manual". Is it ok to use ring function on multimetr to inspect shorts between pins? Because I have only values from 200 to 2000K ohms on multimetr, not 1 ohm.