got it, thanks. im assuming then that i dont have to switch around the IC's then, correct?
thanks much
ianb
--------------------------------------------
On Wed, 10/16/13, Michael Hawkins <korgpolyex800@...> wrote:
Subject: Re: [korgpolyex] hawk crash
To: "korgpolyex@yahoogroups.com" <korgpolyex@yahoogroups.com>
Date: Wednesday, October 16, 2013, 8:03 PM
The advanced sequencer mode has
an bug which I've tried to track down for many months
but I've not been able to find it yet. Just reflash the
software and you should be good to go.
When you reflash the software you will lose any sequences
that you had in memory but your patches should be OK.
Mike
On Wednesday,
October 16, 2013 2:48 PM, Harvey Peekar
<audaciouspen@...> wrote:
hello Hawkers, last night i had a sequence
running on my hawk when the whole thing crashed. i am hoping
that someone here can help me troubleshoot what happened and
how i can go about fixing it.
what happened was i was playing around with the advanced
seq. mode, which i havnt really done yet. i had a sequence
going, which was clocked externally. I hit "Bank
Hold" and "Write" at the same time, (thinking
that i could change the sequence.. i was really just playing
around with it) then it started flashing a bunch, and reset.
after the reset, it goes through the self check, and gives
me "error 4" (no error 5 or 6) which i understand
is a hardware issue, and after that it just loads a
"1" or sometimes an "A". the strange
thing is that i had it had a total running time of about 20
hours with no trouble, and it hadn't moved from its
spot. i can still access the tools function, but there is
no sound or patch banks anymore. everything up until this
has worked flawlessly. Did i erase everything? if so can i
just re-flash the operating system back on it and reload the
patches? im not sure how i can check for hardware
problems... and if i
re-flashed it, do i need to change around the positions of
the IC's first? any advice that's offered would be
greatly appreciated.
thanks much,
ianb