hello Hawkers, last night i had a sequence running on my hawk when the whole thing crashed. i am hoping that someone here can help me troubleshoot what happened and how i can go about fixing it.
what happened was i was playing around with the advanced seq. mode, which i havnt really done yet. i had a sequence going, which was clocked externally. I hit "Bank Hold" and "Write" at the same time, (thinking that i could change the sequence.. i was really just playing around with it) then it started flashing a bunch, and reset. after the reset, it goes through the self check, and gives me "error 4" (no error 5 or 6) which i understand is a hardware issue, and after that it just loads a "1" or sometimes an "A". the strange thing is that i had it had a total running time of about 20 hours with no trouble, and it hadn't moved from its spot. i can still access the tools function, but there is no sound or patch banks anymore. everything up until this has worked flawlessly. Did i erase everything? if so can i just re-flash the operating system back on it and reload the patches? im not sure how i can check for hardware problems... and if i
re-flashed it, do i need to change around the positions of the IC's first? any advice that's offered would be greatly appreciated.
thanks much,
ianb