Ok thanks Mike
It means that my 8085 disassembler is... humm... (it reports this sequence as unknown instruction... like most of the RST vectors entries). I did not check in the datasheet to be honnest, just trusted the software
I will try another disassembler then (for those being interested : the problem I saw comes from DASMx. It worked perfectly to disassemble the 6303 code from my DSS1... but clearly not the case for the 8085)
Is there a 8085 disassembler you would recommend Mike ?
Benoit
--- In korgpolyex@yahoogroups.com, Michael Hawkins <korgpolyex800@...> wrote:
>
> It is not corrupt.
>
> 06 B9 is mvi b, 0B9h
>
>
> Mike
>
>
>
> ________________________________
> From: benoitdmx <benoit@...>
> To: korgpolyex@yahoogroups.com
> Sent: Wednesday, June 26, 2013 8:35 AM
> Subject: [korgpolyex] EX800 EPROM file corrupted in Files section ?
>
>
>
> Â
> Hello guys,
>
> I started some investigations on the EX800 firmware, and I tried to disassemble the binary file located in the Files section (EX800 firmware)
>
> As far as I can see, the file is corrupted : the first bytes are 06 B9 for address 0x0000 (the reset vector). And there are no instructions with 0x06 prefix in the 8085.
>
> I will try to compare the file with the EPROM content in my EX800, but if somebody already made another dump and can compare it too...
>
> Benoit
>