> Those are the data values needed to select a particular parameter. Before you say it, you're right, it's confusing at best and downright silly at worst. I shall redo that sheet soon.\
>
> Mike
I began to assume they were ref#'s meant for the firmware and not actual MIDI CC's.
I'm guessing it wouldnt be too terribly difficult to assign parameters to open CC#'s thru code alterations?
NRPN is a great tool... it's just had to make me completely readjust my gameplan for a custom controller project I've been slowly putting together.
I'll get it working with NRPN, it just might not have all the features I thought I could design into it.
On another note, I finally ordered some encoders, D flipflops and quad bi lat switches.
I should have a working data dial to put in a Poly here in about a week ;)
-Blaine