Thanks for your reply, Mike. Yes I had already changed global parameter to 0 and got communication with the synth, but I can't see an obvious solution to this, it may lie with the software I'm using??
Dan
--- In korgpolyex@yahoogroups.com, Michael Hawkins <korgpolyex800@...> wrote:
>
> The NRPN MSB must be equal to global parameter 16.
>
> The default value for global parameter 16 is 1 (not zero).
>
> So perhaps you need to set NRPN MSB to 1 or change global 16 to zero.
>
> Mike
>
>
> ________________________________
> From: dpaulo2 <dpaulo@...>
> To: korgpolyex@yahoogroups.com
> Sent: Sunday, August 5, 2012 8:57 AM
> Subject: [korgpolyex] question about NRPNs
>
>
> Â
> Mike,
> It took me a while to get my PC to communicate with the Hawk800, but finally made it with NRPNs. I'm trying to get a software editor going.
>
> However I have the following problem:
> In sending the NRPN code I see the the correct numbers are going to the Hawk, for instance:
> 99,0,
> 98,24 (for filter cutoff),
> 6,0
>
> However, that last 0 is being read by the synth as a zero, and I find that I can't vary that figure. My software allows me to create a GUI with sliders, and whilst the slider does show the number changing, the synth remains fixed on 0. This is msb_value I guess, but what can I do to turn that 0 into a variable "x"? I have also contacted the developers of my software with the same question.
> Thanks
>