After getting my HAWK800 up and running, I noticed the parameters wont stop at min/max values, instead they go from like, 99 (max value for VCF cutoff), not stop there and then go over to 0, or backwards down to 0 and then 99.
Is this something that would be terribly difficult to change back to the old way?... Where the # will stop at max or min. value, even though you are still holding down the UP/Down button.
Just curious, it's new to me, so it was like, "STOP! Dangit!", when I was tweaking the parameters.
I've yet to get a midi controller hooked up and curious if this would happen with one of those as well.
-Blaine