Yes, I'm sure it is, I bet it is just before pin 19, if you follow
the tracks you will find it, connect the tip of your audio signal
to the negative leg of the cap and the sleeve to ground, using
the switch method you can select between noise and external
audio, I just can't remember the cap number, it's a shame I don't
have notes on these mods as I do mods for clients and I'll have
one Poly 800 from a client comming in my direction soon, anyways
I'll have to open up mine to swap a connector and I could check
it out for you, but I'm not sure when I'll have time for this.
You can also send it to me for a complete modification service,
I'll do all the mods for you for 299 USD plus shipping and VAT,
the thing is I'm in Brazil so shipping rates are a bit higher than
usual, also one will never know if there will be taxes when it get
in here or not, unless you ship it as a gift. Anyways check the
ph otos of my mods in here:
http://groups.yahoo.com/group/korgpolyex/photos/album/28347805/pic/list
As you can see they look good, work very well and will take any Poly 800 to
another level. The mods are:
1 - CUTOFF and RES pots
2 - NOISE LEVEL pot
3 - FM pot (OSC1 to VCF)
4 - VCF EXT CV input pot
5 - VCF EXT CV input connector (1/4 TS or 3.5mm jack)
6 - VCF EXT CV input switch (ON/OFF)
7 - VCF EXT AUDIO input pot
8 - VCF EXT AUDIO input connector (1/4 TS or 3.5mm jack)
9 - VCF EXT AUDIO input switch to select between EXTERNAL AUDIO and NOISE
10 - VCF SLOPE switch to select between 12dB and 24 dB operation modes
I'm working on printed labels covered with transparent plastic wich
will put a name in every newly added pots, switches and connectors,
these are included in the 299 USD price and I assure you they will
look fantastic.
Cheers,
Bill Meirelles
Em 18/07/2011 04:04,
7yash < josh.nursing@... > escreveu:
Hi Bill,
Looks like wiring through a cap is the way to go.
I found this existing thread. It is not easy to make full sense of it as it is:
http://launch.groups.yahoo.com/group/korgpolyex/messages/311?threaded=1&m=e&var=1&tidx=1