the ex doesn't transmit any midi, only when turn off and on again (system reset). What should it say??
--- In korgpolyex@yahoogroups.com, Michael Hawkins <korgpolyex800@...> wrote:
>
> But does your EX-800 transmit MIDI? It would seem incredibly weird to me if the PC900 replaced would have changed the transmit side.
>
>
>
>
> ________________________________
> From: ariebruus <ariebruus@...>
> To: korgpolyex@yahoogroups.com
> Sent: Thu, January 21, 2010 2:06:29 PM
> Subject: [korgpolyex] Re: a broken ex800
>
>
>
>
> --- In korgpolyex@yahoogro ups.com, Michael Hawkins <korgpolyex800@ ...> wrote:
> >
> > If your are not seeing any MIDI messages coming out of the EX then I doubt it is the PC900.
> >
> > I would suggest start checking voltages and waveforms (with a scope) around:
> >
> > IC26, DTA1, IC27, DTC1, IC28. See the schematic.
> >
> > Mike
> >
> >
> >
> >
> > ____________ _________ _________ __
> > From: ariebruus <ariebruus@ ..>
> > To: korgpolyex@yahoogro ups.com
> > Sent: Thu, January 21, 2010 4:54:38 AM
> > Subject: [korgpolyex] Re: a broken ex800
> >
> >
> >
> >
> > --- In korgpolyex@yahoogro ups.com, Michael Hawkins <korgpolyex800@ ...> wrote:
> > >
> > > Also, change programs and see if the EX-800 is sending MIDI out program change messages. Then check the channel of those messages.
> > >
> > > Mike.
> > >
> > >
> > >
> > >
> > > ____________ _________ _________ __
> > > From: Electrohead <electrohead2000@ ...>
> > > To: "korgpolyex@ yahoogro ups.com" <korgpolyex@ yahoogro ups.com>
> > > Sent: Wed, January 20, 2010 9:55:47 AM
> > > Subject: Re: [korgpolyex] Re: a broken ex800
> > >
> > >
> > > I agree. Check ur channel settings. Try using a midi monitor program like midi-ox to make sure there isn't a problem with the computer you are using. Also try using a different cable.
> > > After that, then I'd start checking for a loose connection inside. Particularly if you've had it apart.
> > > Good luck!
> > >
> >
> > Thanx, i'm sure i've got the right midi channel (midi-ox is sending on all channels). I've checked every possible way to make sure it isn't a cable or parameter. I've also checked with another midi device an that works fine. I use midi-ox to monitor the midi messages. The only time the ex sends out a message is when i turn it off and on again. Then midi-ox gives the message: device reseting. It doesn't send out a message when i change program or press start/stop (i guess it normally does send a message??). I did not check if there's a loose wire inside, will do that asap. I'll also try to replace pc900, but first fool around some more without using a soldering iron.
> >
>
> I'm happy, because the ex is on again!! It was indeed the pc900. I swopped it for a new one and it worked right away! Thank you all again for saving another korg with all this info.
>