If I recall, VR1 is the +5V setting - which means you ought not to be
twiddling with it. Instead, make sure you set the rail to +5V and
leave it alone after that.
How can you see program 11 if the keyboard is in sequencer edit mode?
Is there any sign of moisture corroding anything on any of the boards?
Is there any corrosion near the backup battery (if it is installed on
the main board)?
Mike.
--- In korgpolyex@yahoogroups.com, "m.sislack" <m.sislack@...> wrote:
>
> --- In korgpolyex@yahoogroups.com, "korgpolyex800"
> <korgpolyex800@> wrote:
> >
> > When you say "sequencer mode", do you mean the Poly always jumps
> into
> > playing the sequence or does it jump into sequencer edit mode?
> >
> > If you mean it is dropping into sequencer edit mode, then you must
> > have the sequencer enable switch on the back set to enable (and most
> > likely the sequencer play button is stuck down too). To prove this,
> > set the sequencer switch on the back to disable. Then power off and
> > back on the Poly. Then see if the sequencer starts playing the
> > sequence or does it just behave normally but you are unable to play
> a
> > sequence?
> >
> > Mike.
> >
>
> Hi Mike!
>
> Whn power ist switched on it seems to be in sequencer-edit-mode no
> matter if the switch is enable or disable, program-number sais 1.8
> but you can´t change it either. When VR1 is turned the display starts
> to show weird things an the Poly makes weird noises until the display
> tuns into "TAPE"-mode. No change can be made by pressing any buttons.
>
> Moe
>