| previous by date | index | next by date |
| previous in topic | topic list | next in topic |
On Wed, Aug 20, 2008 at 12:05 AM, Florian Anwander <Florian.Anwander@consol.de> wrote:Hi Danjel.
What is exactly the source of the gate-signal? The monopoly expects (and
sends) +15 Volts as gate. And the real threshold is set by R63/R62 at
KLM-355 (both versions). According to the nominal resistor values the
threshold is at 2.5 Volts, but it may vary with extrem values within the
the variation of the resistors.
If your gate has only 5 Volts and comes from a MIDI-to-CV/Gate interface
with a weak output, then the gate-signal may not trigger the gate
recognition around IC5.
You might insert a trimmer of 47k between R63, R62 and +Input of IC5:
one end of the trimmer to R63, the other end of the trimmer to R62, and
the wiper of the trimmer to pin 3 and R64. With this trimmer you could
set the threshold manually.
Florian> ------------------------------------
intellijel wrote:
> When I sequence the monopoly from an external sequencer via the
> CV+trig in the sequence is totally in consistent. I get
> dropped/skipped notes frequently and the sequence never stays locked
> and conistent.
>
> When I trigger the arpegiator (using a gate2s-trig cable) it is no
> problem to stay locked.
>
> What is the solution to this problem?
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
--
Florian Anwander |ConSol∗
Tel. +49(89)45841-133 |Consulting&Solutions Software GmbH
Fax +49(89)45841-111 |Franziskanerstr. 38, D-81669 München
email: florian.anwander@consol.de |http://www.consol.de