| previous by date | index | next by date |
| previous in topic | topic list | next in topic |
A 110Kohm resistor in parallel with the outer lugs of one 1M pot will give you a total resistance of 99.09Kohm.
Peter
From: emlsynth@yahoogroups.com [mailto:emlsynth@yahoogroups.com]
Sent: February 17, 2015 1:53 PM
To: emlsynth@yahoogroups.com
Subject: [emlsynth] EML 200 pot replacement
I just acquired an Electrocomp 200 with scratchy pots, and am looking for advice. The Allen-Bradley type J pots are fine, but the square cermet "mod pots" (modular potentiometers) did not survive the last few decades and can't be repaired because of the way they're constructed. For the ones that are just a single value I'm replacing them with other pots, but the problem is the two filter cutoff frequency controls, where a single shaft simultaneously turns two pots of different values (100k and 1meg). I can't find any new old stock, and to have replacements custom manufactured by potentiometer.com would cost $45 each with a $50 low volume fee and $15 shipping, so that sounds like a last resort. Anyone else have suggestions?
-thomas