Thanks WT, I'll route it through a splitter then. :)
While at it, two of my MTM's has version 4 and one has version 3 of the
software. If there is one freezing up from now and then it's the one
with version 3. Does anyone recognise this behaviour?
--
electronically yours, jesper
- -- --- ---- ----- ---- --- -- -
www.electronic-obsession.se
WT skrev 2011-12-10 18:53:
> Í´ve had problems with my MTM´s in this respect too. Midi thru not working
> properly.
>
> Get a separate midisplitter.
>
> WT
>
> ----- Original Message -----
> From: "jesper" <jesper@...
> <mailto:jesper%40electronic-obsession.se>>
> To: <Simmons_Drums@yahoogroups.com <mailto:Simmons_Drums%40yahoogroups.com>>
> Sent: Saturday, December 10, 2011 6:46 PM
> Subject: [Simmons Drums] MTM and midi thru
>
> >I do remember having hooked up my two MTM's so that thru of the first
> > went to midi in on the second. Both were on the same midi channel and
> > responded to different note numbers when played from a midi keyboard.
> >
> > Today the second won't listen to incoming commands. I bypassed the first
> > and the second works. This makes me think that I somehow forgot some
> > software setting.
> >
> > Same goes for the new third MTM that arrived today. All works but it
> > won't listen to midi when fed from any of the others thru output.
> >
> > The manual is no help... are you guys? :)
> >
> > --
> > electronically yours, jesper - will check my cables now as an extra
> > precaution...
> >
> > - -- --- ---- ----- ---- --- -- -
> > www.electronic-obsession.se