The ZIP is functioning but the device itself has a problem. In SCSI
terms ZIP has a special way of formatting (disk layout). The SDX
cannot format this drive as a result.
If you have only one drive on the SCSI chain termination is not a
problem. As soon as you add another drive, it is important to use
passive or active termination.
--- In
Simmons_Drums@yahoogroups.com, "rolandbrenner@..."
<rolandbrenner@...> wrote:
>
> Well as I mentioned previously, I removed the HD from the chain so
therefore the zip was the only device other than the floppy. SCSI
devices have a way of terminating ( or as you refer "addressing" ) by
either switches ( Zip ) or resistor packs ( HD's ). I'm no expert
myself, but I have to believe by removing all other devices in the
SCSI chain, the computer should at least try to access the zip drive
on boot up. I actually used this method to troubleshoot and perfect
the HD installation procedure.
>
> The media issue would be secondary as ( again ) the drive itself is
not currently recognized by the SDX. In other words, you can not
format a disk that is in a non-functional drive.
>
> Anybody else have any info they could possibly share before all my
hair is gone?
>
>
> - Roland
> http://www.myspace.com/roland_brenner
> Do you possibly have any conflicts with your SCSI adressing? You
know you need to
> assign unique adresses to each SCSI device in the chain. The ZIP
media need to be
> formatted just as the internal harddrive before you can use. It's
exactly the same
> procedure
> Bye
> Wolfgang
>
> ____________________________________________________________
> Click to see huge collection of designer watches.
>
http://thirdpartyoffers.netzero.net/TGL2231/fc/Ioyw6ijlxzCg53842U0TbuS439msAcLlI5ZxaRlYmCMgNtckbOSgQa/
>
> [Non-text portions of this message have been removed]
>