yo dave
i'm not quite cipherin' the mixer input trick. how do you sweep them w/
an lfo? i see three logic pins.
Scott Deyo
The Bridechamber
contact@...www.bridechamber.com
On Oct 11, 2007, at 10:40 PM, david wright wrote:
> hey everyone - i have an snvoice on a a 4U panel using big switches
> and rotaries.
> i would prefer it was 2U (3u at max) - i find the rotaries for pulse
> width could
> be replaced with a spst between LFO/ENV modulation, the rotary for the
> lfo speed could be a center off mini switch for three speeds, i could
> live without
> the fine tune control, i could deal with less CV inputs and attuns, i
> like scott's mod
> for changing the env response, but could just do it with a trimpot. i
> really enjoy
> to have the mixer inputs to an input jack - its allot of fun to send
> an lfo into them
> to sweep from noise/vco/lfo etc. look there its almost 2U - but still
> a few pots
> n jacks too much - any other opinions? i could deal without the pulse
> width inputs
> because the lfo/env do such a good job allready
>
> what a great module -
>
> dave
>
> On Oct 11, 2007, at 12:57 PM, Scott Deyo wrote:
>
>> I'll try to get to this one, but it will be a little while.
>> What options do people want to see in it?
>>
>> Scott Deyo
>> The Bridechamber
>> contact@...
>> www.bridechamber.com
>>
>>
>> On Oct 11, 2007, at 12:02 PM, gino wong wrote:
>>
>>> I just ordered a pcb for an SN 76477 module. Most of us have messed
>>> around with these things for years. So Tom Henry tricked it out and
>>> another fella came up with a pcb (run of 50) uses a cd4046 PLL.
>>>
>>> I want to do it as a 2-3u voice panel.
>>>
>>> Do I have any brethren ?
>>>
>>> best
>>>
>>> gino
>>>
>
> dave wright
> www.notbreathing.com
> bastardita@...
>
>
>
>
>
>
>