hey everyone - i have an snvoice on a a 4U panel using big switches and rotaries.
i would prefer it was 2U (3u at max) - i find the rotaries for pulse width could
be replaced with a spst between LFO/ENV modulation, the rotary for the
lfo speed could be a center off mini switch for three speeds, i could live without
the fine tune control, i could deal with less CV inputs and attuns, i like scott's mod
for changing the env response, but could just do it with a trimpot. i really enjoy
to have the mixer inputs to an input jack - its allot of fun to send an lfo into them
to sweep from noise/vco/lfo etc. look there its almost 2U - but still a few pots
n jacks too much - any other opinions? i could deal without the pulse width inputs
because the lfo/env do such a good job allready
what a great module -
dave
On Oct 11, 2007, at 12:57 PM, Scott Deyo wrote:
I'll try to get to this one, but it will be a little while.
What options do people want to see in it?
Scott Deyo
The Bridechamber
www.bridechamber.com
On Oct 11, 2007, at 12:02 PM, gino wong wrote:
I just ordered a pcb for an SN 76477 module. Most of us have messed
around with these things for years. So Tom Henry tricked it out and
another fella came up with a pcb (run of 50) uses a cd4046 PLL.
I want to do it as a 2-3u voice panel.
Do I have any brethren ?
best
gino
dave wright
www.notbreathing.com