Dave,
It looks good. The jacks are a little farther apart horizontally, and
closer vertically, than MOTM, but it should work just fine. I only
state the differences in case those are important to you. But for
what you have on the panel, it's a good layout. Smart to keep the
keyboard cv's to the side.
The Euro is about equal to the dollar last time I checked. When I pay
for it, you can send me money via Paypal or check or whatever.
Schaeffer's not the best at communicating lately. I asked a couple
questions twice now, w/ no response. This isn't atypical for them.
Orders take anywhere from two weeks to two months in my experience. I
think they're a small company, w/ all the attached pros and cons
there.
Scott
--- In motmpanels@y..., "djbrow54" <davebr@e...> wrote:
> I'm currently waiting for my MOTM modules to arrive. I need to
build an interface for my Arp 3604 CV keyboard and designed and
uploaded a 2 wide MOTM style panel. It's in the DIY Designs,
Schematics folder called diy_cvkbd.fpd. I'd appreciate having
someone check it and tell me if it's OK. Since I don't have a MOTM
panel yet I guessed at some of the line spacings. It's pretty
simple, just some 1/8" and 1/4" jacks for CV, Gate, and Trigger and a
power connector. Am also open to any suggestions.
>
> I'm also curious as to how one pays for this, how long it takes,
etc. Also, what's the conversion rate for euros?
>
> Thanks. - Dave