Archive of the former Yahoo!Groups mailing list: Modular Synth Panels

After many weeks of planning, ordering, and assembly, I finally have a
Milton sequencer up and running. I've uploaded a Schaeffer front panel
design to a new folder called Milton.

The panel is 8U motm units wide and is designed for step led's at the top
of the panel, then 4 bank boards (64 pots!), then pulse bank switches,
control and output sections, and gate outputs at the bottom of the panel.

Holes are for SWitchcraft 112 sockets, pot holes are for the pots
recommended in Milton's parts list (these are a tight fit with the
panel's thickness), pushbutton holes are for E-Switch
pushbuttons, switch holes are for Mountain switches, and led holes are
for some cute chrome dome type leds (from Lumex, IIRC).

One word of caution: Because of space constraints, the switches are
located ∗very close∗ to the lowest bank board (lowest row of pots).
So if you decide to use this panel, please check spacing with
your components (as well as for anything else - standard procedure).

Comments appreciated. I think Peter will post some photos on his site or
in the Milton yahoo groups.

Jeff