So should each of those 2 junctions go through a 200K resistor (in other words 2 resistors or 1 resistor with 2 wires connected to the other end)?
Thanks!
--- In ModularSynthPanels@yahoogroups.com, Scott Deyo <contact@...> wrote:
>
> Jack to left lug of pot
> Middle lug via 200k resistor (haven't tested this yet, but should be a
> good value) to two places:
> CVSN of Filter B
> Junction of Junction of 100k and 2k2 resistors that go to pin 2 of
> Filter A CV inputs op-amp
> Right lug to ground
>
> So, the effect should be, putting 5V in, with pot turned all the way
> up, Filter A should go down around 2V5-worth of frequency, and Filter
> B should go up an equal amount.
>
> Scott Deyo
> contact@...
> The Bridechamber
> www.bridechamber.com
> Jealous Edison Record Kompany
> www.jealousedison.com
>
>
>
>
> On Feb 11, 2010, at 5:14 PM, joshdaigleusa wrote:
>
> > How is the spread CV on the bridechamber panel for the CGS CMOS VCF
> > pansl wired up? I don't see anything on the CGS site and tried to do
> > some searching here but couldn't turn up anything.
> >
> > Thanks!
> >
> >
> >
>