| previous by date | index | next by date |
| previous in topic | topic list |
Thanks Scott, but you don't have to send one out, I can pick one up, no worries. It's an old kit I bought un-assembled from Plord. I've been hanging on to it for almost a year and finally got around to finishing it.
I think I figured it out (I posted over at Muffwiggler) I labeling the jacks on the panel with the numbers on the schematic and came to the conclusion that J9 (PUL/NOISE VOLUME) on the panel wiring sheet is PLS/NS OUT on the panel and gets wired directly to J3-1 on the board with out the 10K pot.
Jack J5 (VC NOISE ATTEN), which on the wiring sheet goes to the 100K VC NOISE ATTEN pot, would be the NOISE CV jack on the panel and would be wired to NOISE FREQ CV.
That's right, right?
Thanks again for these awesome kits!
--- In ModularSynthPanels@ yahoogroups. com, Scott Deyo <contact@... > wrote:
>
> There's a discrepancy between the schems and BOM for the SN voice. I
> don't think it matters whether you use 10k or 100k for the output
> attenuator, though, since I leave that off my panel, it does matter
> and I'll send a 100k to you right away.
>
> Scott Deyo
> contact@...
> The Bridechamber
> www.bridechamber. com
> Jealous Edison Record Kompany
> www.jealousedison. com
>
>
>
>
> On Dec 27, 2009, at 12:40 PM, krelnarb wrote:
>
> > A question to anyone who's built the SN-Voice Bridechamber kit. OK,
> > this is my final push to finish this SN-Voice and I'm befuddled on
> > the placement of a couple of these pots. All the pots (100K & 1M)
> > are in place except:
> >
> > On the panel wiring sheet there's PULSE/NOISE VOLUME (10K), VC NOISE
> > INIT (100K) and VC NOISE ATTEN. (100K) On the panel there's NOISE
> > FREQ and NOISE FREQ CV. I have a 10K and a 100K pot left. Which one
> > goes to which?
> >
> > Or is there another wiring document for this kit I don't know about?
> > despair
> >
> > Thanks in advance for any help what so ever.
> >
> >
> >
>