previous by date | index | next by date |
previous in topic | topic list | next in topic |
On 28 sep 2009, at 07:43, Dave Halliday wrote:
> The tants had a really good high frequency response IIRC -- good for
> filtering out noise as well as 60Hz.
>
> My technique was to follow the power buss on the circuit board and
> find an
> arbitrary mid-point that was away from any critical wiring and use a
> dremel
> tool to sever it.
>
> Find out which half had the short and proceed until you had three or
> four
> caps to test. Unsolder one lead and lift the leg and test the power
> buss
> again.
>
> I could usually find a dead cap in 10-15 minutes. A good friend of
> mine
> nearly fainted when I dug into his Odyssey although he had thought the
> problem was in the power supply and had disassembled it. Took me
> longer to
> put that together than to find and replace the dead tant.
>
> Scrape the traces on each side of the dremel cut and solder a bit of
> solid
> wire to bridge the gap.
>
> Dave
>
>> -----Original Message-----
>> From: ModularSynthPanels@yahoogroups.com
>> [mailto:ModularSynthPanels@yahoogroups.com] On Behalf Of
>> Richard Brewster
>> Sent: Sunday, September 27, 2009 6:32 AM
>> To: ModularSynthPanels@yahoogroups.com
>> Subject: Re: [ModularSynthPanels] ChaQuo Wiring Question...
>>
>> I'd not use any tantalum caps. Their main benefit is the
>> smaller size
>> vs electrolytic of the same specs. They also cost more. I
>> have one of
>> my own tales from the days of yore. I used to hand-build audio and
>> video synthesizer circuits in the seventies. These were all
>> prototypes
>> and needed plenty of power line bypassing. At one point we
>> used a bunch
>> of 100 nf Panasonic tantalums. We might put 20-30 of them on
>> a board.
>> And yes, they did fail by shorting out. But unless it fried
>> and burned,
>> we could not tell which one failed. So, one by one, each had to be
>> clipped out until the bad ones were found. Then all the "good" ones
>> that had been removed too had to be replaced. Needless to say, we
>> stopped using the tantalums. If you do want to use some, I'd
>> recommend
>> ones with at least a 35 volt rating.
>>
>> Richard Brewster
>> http://www.pugix.com
>>
>> mcb, inc. wrote:
>>> On Sat, 26 Sep 2009, Scott Deyo wrote:
>>>
>>>
>>>> Yeah, I torched a polysty on mine too. That's probably the
>> culprit. Polysty's
>>>> and tantalums are bummin' me out lately...
>>>>
>>>
>>> Speaking of tantalums, came across this interesting tale from
>>> days of yore:
>>>
>>>
>> http://www.designnews.com/blog/Made_by_Monkeys/23362-Do_You_Wa
>> nt_Butter_On_Those_Capacitors_.php?nid=3073&rid=398497
>>>
>>> --
>>> Monty Brandenberg
>>>
>>>
>>
>>
>>
>> ------------------------------------
>>
>> Yahoo! Groups Links
>>
>>
>>
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>