Archive of the former Yahoo!Groups mailing list: Modular Synth Panels

This is a difficult panel. It doesn't fit into 2U. I voted for the
vertical, because I didn't like switches mixed in with jacks on the
bottom on the horizontal design.

Richard Brewster
http://pugix.com

Scott Deyo wrote:

>
>
> Yeah, I always balk at moving jack above pots, though that's a little
> silly. If you have more than one row of modules, you're going to get
> cords over your pots anyway, right?
> What do others feel about this?
>
> I really wanted to do 2U, but I don't think folks (and I count myself
> as one of these folks) have access to concentric pots.
>
> Scott Deyo
> contact@... <mailto:contact@...>
> The Bridechamber
> www.bridechamber.com <http://www.bridechamber.com>
> Jealous Edison Record Kompany
> www.jealousedison.com <http://www.jealousedison.com>
>
>
>
>
> On Aug 22, 2009, at 3:55 PM, John L Rice wrote:
>
>>
>> Wow, tough call! If I were doing it for myself, I would do one of
>> two things. If I went with the horizontal version I’d go off the
>> standard MOTM grid and move filter A’s jacks up into the section with
>> the controls and move section B down a bit etc. But if I really was
>> going to build this I would do the vertical design but in 2U instead
>> of 3U by combining the Frequency and Frequency CV controls into a
>> dual concentric pot (if possible), moving the Mode switches down to
>> where the Frequency CV controls were and then move the Input jacks up
>> and the Output jacks over underneath the Input jacks.
>>
>>
>>
>> John L Rice
>>
>>
>>
>> ∗From:∗ ModularSynthPanels@yahoogroups.com
>> [mailto:ModularSynthPanels@yahoogroups.com]
>> ∗Sent:∗ Saturday, August 22, 2009 1:16 PM
>> ∗To:∗ ModularSynthPanels@yahoogroups.com
>> ∗Subject:∗ [ModularSynthPanels] New poll for ModularSynthPanels
>>
>>
>>
>>
>>
>>
>> Enter your vote today! A new poll has been created for the
>> ModularSynthPanels group:
>>
>> For an MOTM-format CGS Dual CMOS Filter, do you prefer the vertical
>> or horizontal layout?
>> They're in the Proposed Bridechamber Designs folder.
>>
>> o Vertical
>> o Horizontal
>>
>> To vote, please visit the following web page:
>> http://groups.yahoo.com/group/ModularSynthPanels/surveys?id=2220793
>> <http://groups.yahoo.com/group/ModularSynthPanels/surveys?id=2220793>
>>
>> Note: Please do not reply to this message. Poll votes are
>> not collected via email. To vote, you must go to the Yahoo! Groups
>> web site listed above.
>>
>> Thanks!
>>
>>
>
>
>
>