I got some ueg knobs, smaller version of the "oficial" MOTM knob. I think
your design uses the same spacing than mine(.8" between pot centers) so they
can`t work ... I printed my fdp design and tried to align them but you`ll
need more spacing... Also, the pots have a 6mm D shaft and the ueg`s are
1/4". We need smaller knobs, 10-11mm. max diameter.
Thanks,
Josue Arias.
PS. I like your design and it`s very much like mine. I preffer some lines
for separating the sequencer channels and the in/outs section.
----- Original Message -----
From: "elle_webb" <elle_webb@...>
To: <motmpanels@yahoogroups.com>
Sent: Monday, June 23, 2003 11:05 PM
Subject: [motmpanels] Re: Milton monster sequencer - feedback requested
> I'd like to find out what is used on the UEG. They are smaller
> versions of the MOTM knobs. Anybody have a source or part number for
> these?