Thanks very much Howard for the photos. I have been considering the
"jack only" mounting option, I was considering something almost
exactly like you have shown. 2 jacks are plenty strong for holding a
bracket.
2 issues:
1: Should I make the jack spacing fixed? That works OK for one
direction but not for the other. Or, should I make one round and
make the other elongated (like my normal bracket pot holes) so
thatnthere is lattitude for jack spacing.
2: If you have a 1U or 2U module in the MOTM upright format, your
mouting bracket is near the bottom edge. That's OK. BUT, they will
not fit into the bottom row of slant cabinets.
Thanks again Howard. I need feedback to make this reality.
Larry
--- Howard Ulyate <
knarleybass@...> wrote:
> I could have use some sort of Ken Stone compatable
> MOTM mounting bracket. I am sure that Larry would
> make something alot better than what I came up with
> today for my project...
>
> Howard
>
> http://www.bobknarley.com/synth.html
>
__________________________________________________
Do you Yahoo!?
The New Yahoo! Search - Faster. Easier. Bingo
http://search.yahoo.com