Great, I just finished having mine drilled for leds so I can add switches.
Maybe you could add a little wiring diagram for guidance ( like one of 8) and exactly where
to cut the trace.
>
> hey all,
>
> so i finished my sequential switch/ event sequencer this morning. it
> roolz, all other seq's droolz!
> ; )
>
> the up/down control, the reset and inhibit controls, inverted output,
> mix input -- what a great module!
> adding LFOs to certain steps makes it very very very fun, or even audio
> -- get some FM klang on every fifth step, for example.
>
> i added a gate bus jack for the switches, w/ a diode between each gate
> output and switch, all switches' middle lugs bussed to the jack --
> works great, but i used four different-colored LEDs, and not all gates
> are at the same level (very close though). i'll take the tradeoff for
> prettiness.
>
> the bridechamber glide DOES NOT WORK when inserted before the mixer
> output. the 4051 must be sendin' somethin' the glide doesn't like. i
> think the 358 locked up, which was weird. maybe it was the 4051,
> though; i didn't test it. so i put the glide after the circuit's
> outputs, using a dual-gang pot for glide.
>
> the audio-rate glide works well at audio-rate clocking. now if only we
> had an ultra-sonic VCO... maybe just maybe someone will be coming out
> w/ one pretty darn soon (hint hint)...
>
> my step selection rotary is a little weird, though. some steps are
> skipped, though i've checked my wiring 10 times...
>
> i love this module. there is a forest of wire back there, so put on
> some good tunes and relax; it'll take a while.
>
> i'll be adding final pics to the site today or tomorrow, and i'll work
> on some sound samples too.
>
> cheers,
> Scott Deyo
> The Bridechamber
> contact@...
> http://www.bridechamber.com
> Jealous Edison Record Kompany
> http://www.jealousedison.com
>