Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

> http://www.misterart.com/store/view.cfm?store=001&group_id=3700

Will check that out. DO you have any suggestions for a spray-on
protection? I would think a laquer would eat the film.

> A simple plug-n-play setup using drivers from here;
> http://www.cadcamcadcam.com/index.asp?PageAction=VIEWPROD&ProdID=11

Rats, current is too low for my needs.

> http://www.geckodrive.com/item.htbml?order_id=0&item_id=G320

The 320 is the one I believe I am going with, while still low on
current (20 amps and I need 40), I am hoping it will work for me at
the reduced current. The mechanical gearing I am using should
equalize the lower current as delivered by the Gecko.

Chris