Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

I've had that problem on some of the MG Chemical boards. Overall the
whole setup works very well. I've made a lot of boards this way.

http://www.kd7lmo.net/tech_pcb.html

On Wed, 8 Jun 2005, Robert Hedan wrote:

> "Once I peeled off the backing paper, I found that the edge of the board
> wasn't covered in photoresist - in some places a strip of up to an inch of
> copper wasn't covered in resist. Is this normal??"
>
> I've never had that from MG Chemicals boards. The stuff came right up to
> the edge.
>
> Robert
> :)
>
>
>
>
>
>
>
> Be sure to visit the group home and check for new Links, Files, and Photos:
> http://groups.yahoo.com/group/Homebrew_PCBs
>
> If Files or Photos are running short of space, post them here:
> http://groups.yahoo.com/group/Homebrew_PCBs_Archives/
> Yahoo! Groups Links
>
>
>
>
>
>
>
>
>
>
> Be sure to visit the group home and check for new Links, Files, and Photos:
> http://groups.yahoo.com/group/Homebrew_PCBs
>
> If Files or Photos are running short of space, post them here:
> http://groups.yahoo.com/group/Homebrew_PCBs_Archives/
> Yahoo! Groups Links
>
>
>
>
>
>
>