Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

I don't think it will work so good. For one thing those heat guns produce
1500F that will probably melt the bag. Second if the plastic bag is not
applying good pressure it will leave traces open that did not bond.
I would look for a good t-shirt press or iron even a shirt press might work
good. On these you have control of time, pressure and heat. These are
important for good transfer.
Other things to look for is a flat PCB and clean.
Derek B.
High Tech Systems
Denver, Co.


-----Original Message-----



Turn on the vacuum,
then use the hot air gun to heat the art work on the paper and the
board for about 2 to 3 minutes and that's it. Place the board in
water right after heating and the paper floats away leaving the art
work on the board.
∗∗∗End forwarded message∗∗∗

So, whatdya think?

Steve Greenfield

___