Hi Hans,
Can I put the ground plan in after I do all the other
traces, or should I do a section at a time? I am drawing the
board direct. It is not coming from a diagram made with
Eagle.
John
--- In Homebrew_PCBs@y..., Hans Wedemeyer <hans@c...> wrote:
> John,
> With EAGLE I add a polygon and it fills all available space. The
next
> step is to give the polygon a NET name, and naming it GND will
connect
> it to Ground... ( I assume your are using GND as the ground net of
> course)
> This is what the end result looks like http://hans-w.com/rpm_pcb.jpg
> Hans W
>
> crankorgan wrote:
>
> > Hi Gang,
> > I was wondering if any of you have done a ground plane
> > on a board. When I mill boards I can use the surrounding copper
> > as a ground. With Eagle and other programs I can't find a way to
> > keep the extra copper around the traces. I know I can use the
other
> > side of the board for a ground. I really wanted to stick with a
> > single sided boards.
> > Regards
> >
> > John
> >
> >
> > Yahoo! Groups Sponsor
> ADVERTISEMENT
> [Image]
> >
> > Be sure to visit the group home and check for new Bookmarks and
files:
> >
> > http://groups.yahoo.com/group/Homebrew_PCBs
> >
> > To unsubscribe from this group, send an email to:
> > Homebrew_PCBs-unsubscribe@y...
> >
> >
> >
> > Your use of Yahoo! Groups is subject to the Yahoo! Terms of
Service.
>
>
> [Non-text portions of this message have been removed]