Hello Stefan,
Monday, April 18, 2005, 12:15:25 AM, you wrote:
ST> ok, thanks, let me know the findings. the IC tube is a good idea.
ST> Now if i only had a x/y table or a cnc to get those holes in with some
ST> accuracy...
ST> ST
Let me put my �0.02 onto this
There is a possibility to find the flexible aerator for fish tanks.
I do use one in my etching tank. it makes very small bubbles, and
has the led rod inside for keeping it at the bottom of the tank. The
only thing that you should do is to take it appart, use some
lacquer/paint to chemically insulate the led rod, assemble and glue
it together and you are on. It does not preoduce any streaks on the
pcb during etching.
Will put some pictures of this setup somwhere during next week.
--
Sincerely,
����``````````````````````````````````````````````````````����
ZAS ElMed | mailto:
zasto@... |
http://www.zas-elmed.co.yu | Tel/Fax: +381 11 344-0748
|
Zoran A. Scepanovic | Mob: +381 63 609-993
���,����������������������������������������,�������������,���
∗∗∗∗∗∗∗∗∗
Oops. My brain just hit a bad sector.
∗∗∗∗∗∗∗∗∗
[Non-text portions of this message have been removed]