Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [Homebrew_PCBs] immersed etching

From: "Stefan Trethan" <stefan_trethan@...>
Date: 2005-04-16

On Sat, 16 Apr 2005 14:27:42 -0400, Alan King <alan@...> wrote:

>
> Unconstrained, bigger probably is better, causing more direct action
> in the
> liquid as the bubble moves up. But with more smaller bubbles and being
> kept
> toward the board I doubt you'd see much difference, and of course the
> smaller
> should be more even. There are 8-10 inch long 1/4 inch round green tube
> fish
> aerators that put out lots of bubbles, that's what I'm thinking of.
> Hard to
> find a pic, don't know the brand name and you get too much other stuff
> on a net
> search. May just get a couple for trying later if I go out and send a
> picture.
> Alan


I've found such fish bubblers on ebay, despite warnings they fall apart in
cucl a small one i tested didn't.
The ones on ebay are 30cm long green ones and are only 2eur each. will get
'em.

I see no way getting big bubbles that are not in streaks, one would need a
mighty pump to have holes so closely spaced with large diameter.

ST